Gas work is the plumbing where the margin for error is smallest. A new line for a range, a fire pit or a pool heater, a repair on a line that smells of gas, an appliance hookup done right, all of it has to be leak-tight, pressure-tested and permitted, because the consequence of doing it casually is not a leak, it is a hazard. This is not a job for guesswork or a handyman.
We install, repair and extend gas lines to code, pressure-test every job, pull the permit the work requires, and call Arizona 811 before any line goes in the ground. If you smell gas, the first move is not to call a plumber, it is to get out and call the gas utility, and then call us.
What gas work involves, done safely
The gas work we handle
- ✓New gas runs for ranges, dryers, fire pits, pool heaters and generators
- ✓Repairs on lines that leak or fail a pressure test
- ✓Appliance hookups and shutoff installation
- ✓Extending or resizing a line for added appliances
- ✓Pressure testing and permitting on every job
A new gas line has to be sized so every appliance gets the volume it needs, run in the correct material for its location, and pressure-tested to prove it holds before it is ever put into service. A resized line for a new appliance is common, because adding a load to a line that was sized for less is how you end up with an appliance that starves. We handle the sizing, not just the pipe.
The safety steps that are not optional
811, the code, and why permits protect you
Before any gas line goes in the ground, the law and plain sense say call Arizona 811, the state's call-before-you-dig service, so buried utilities are marked and nobody hits a line. Chandler works to the 2024 International Fuel Gas Code with local amendments, and gas work requires a permit and inspection. That inspection is your protection: it means an independent set of eyes confirmed the work is safe, which matters for your insurance and for anyone who ever buys the house. On something that can burn a house down, the permit is the point, not the paperwork.
If a gas line ever crosses the disturbed ground near the mapped earth fissures toward Chandler Heights, that is exactly the kind of place where ground movement can stress a buried line, and where locating and proper installation matter most. The Arizona Geological Survey has documented fissures exposing buried lines elsewhere in the region, which is why we do not cut corners on gas in this soil.
What gas line work costs
| Job | Typical work | What it depends on |
|---|---|---|
| Appliance hookup | Connect and test | Access and shutoff |
| New line run | Size, run, test, permit | Distance and routing |
| Leak repair | Locate, repair, retest | Where the leak is |
Gas work is quoted to the job after we see the run, because distance, sizing, routing and permitting all matter, and none of it is worth estimating blind. What every quote includes is the pressure test and the permit, because on gas those are not extras. You get the number before the work.
Gas Line Installation & Repair in Chandler, common questions
I smell gas. What should I do?
Leave the house, do not flip switches or light anything, and call the gas utility and 911 from outside. Once the immediate hazard is handled, call us to locate and repair the leak. Your safety comes before the plumbing, always.
Do you pull a permit for gas work?
Yes, always. Gas work requires a permit and inspection in Chandler, and we call Arizona 811 before any dig. The inspection is what proves the work is safe, which protects you with your insurer and at resale.
What does gas line work cost?
It is quoted to the job after we see the run, because distance, sizing and routing all matter. Every quote includes the pressure test and the permit, since on gas those are essential, not optional. You get the number before we start.
Can you add a line for a pool heater or fire pit?
Yes. New runs for pool heaters, fire pits, generators and outdoor kitchens are common. We size the line so it and your existing appliances all get the volume they need, then test and permit it.
Are you licensed and insured for gas?
Yes, licensed and insured Arizona plumbers registered with the Arizona Registrar of Contractors, working to the adopted fuel gas code with permits and pressure testing. Details on request.
Smell gas, or adding a gas appliance?
Describe what is happening and you will reach a plumber, not a form.